I am looking for someone to take some logo’s and carve them into
either metal or a plastic which I can then make a mold of to
reproduce in pewter. Most will only need to be engraved but some
will need to be 2D carvings.
A few will need to be done from art work/ drawings.
I am looking for someone to take some logo's and carve them into
either metal or a plastic which I can then make a mold of to
reproduce in pewter. Most will only need to be engraved but some
will need to be 2D carvings. A few will need to be done from art
work/ drawings.
Would laser etching work?
If you are going to take a mold, you could etch into a soft enough
material to get and vary the depths.
Christopher Lund
Neurascenic - Industrial Design
Try Rick Bilodeau at Wenric’s in San Jose CA Works with distant
clients.
http://www.ganoksin.com/gnkurl/ep7zxd
Very good work by someone who understands how to CAD and fabricate.
Sam in San Jose
Laser etching will work I have used it in the past for some of the
logo’s I have done for businesses.
Vernon Wilson
Thanks Sam will give them a try. I used to do this all by hand but
is too time consuming and by using this technology it opens up my
time to make other things
Vernon Wilson