the sttings should vary depending on the numbers of cylinders inside
the kiln? right? kinda of normal when you think about it. the only
times i casted berfore was at jewelry school and we had a computer
doing all the job. I have done some testing on the relating to the
control setting/temperature and found that at number five i’m in
condition to maintain 1350F . for the moment i dont feel like i
should leave the kiln for too long, specialy noe overnight(which i
would find normal to do) i will keep on testing degrees obtained
versus numbers of cilynders versus control seeting but if somehow ,
anyone should have info , i would really appreciate saving time and
money!
tank you again