Back to Ganoksin | FAQ | Contact

Hydraulic Stamping


#1

Hi all,

I am looking at buying a press - hydraulic or manual to stamp a
range of jewellery from 0.5mm silver sheet.

Can anyone recommend a UK supplier and does anyone know what sort of
tonnage I should be looking at?

Thanks in advance for any help…
Helen Smith
helen @ design256.com


#2
  I am looking at buying a press - hydraulic or manual to stamp a
range of jewellery from 0.5mm silver sheet Can anyone recommend a
UK supplier and does anyone know what sort of tonnage I should be
looking at? 

Helen, I don’t know of a U.K. supplier but if you go to
http://www.bonnydoonengineering.com you will obtain a lot of
I’m sure what you want is obtainable from Lee Marshalls
company.

Regards,
Tony Eccles.


#3
I am looking at buying a press - hydraulic or manual to stamp a
range of jewellery from 0.5mm silver sheet. Can anyone recommend a
UK supplier and does anyone know what sort of tonnage I should be
looking at? 

Hi Helen, check out www.bonnydoonengineering.com, and take a look at
the Discussion Group, too. I believe that Lee Marshall will be in
England again this summer teaching about the hydraulic press. Regards,
Cindy Cynthia Eid www.cynthiaeid.com