I am currently working on an article for MJSA Journal on mold
cutting. After reading what the books I have on the shelf have to
say on the subject and reviewing the Orchid archives, i have already
come to the conclusion that you can explain the basics in a couple of
paragraphs, but fully exploring the subject would take volumes.
Nevertheless, I must do the best I can within the confines of
magazine article, and so I am turning to the wonderful Orchid
community for help.
What do you consider the most important thing you ever learned about
What basics do you think are easily overlooked?
What are your favorite mold cutting tools?
Are there any tricks you have discovered that you wish you’d known
when you started?
I’m also looking for volunteers to discuss their methods, if anyone
is willing to set aside a few minutes in the coming week for a
Fax: (928) 563-8255