Back to Ganoksin | FAQ | Contact

[Source] Tungston carbide square hole drawplate


#1

Can some one tell me where I can purchase a tungsten carbide square
hole draw plate that goes down to hole size.26 mm. I have not had
good success drawing very small fine gold wire on steel draw plates.

Thank You Jerry Huddleston Engraver.


#2

Jerry have you tried a little burr lube on your wire before you
start your pull? Wax will also work.

Frank Goss


#3

Frank.

Jerry have you tried a little burr lube on your wire before you
start your pull? Wax will also work

Thanks for the tip but I work almost exclusively with 24K and it
just doesn’t pull well in small sized thru a steel plate.