Back to Ganoksin | FAQ | Contact

Drawplates: how do you find the last hole drawn?


#1

Brilliant as usual, Jeff! Thanks!

Kathy


#2

Great idea…

I also use a magnet for my rolling mill. I stick a opened paper clip
on the manger stuck to the base of the mill then simply move the
other end into the next grove of my mill so I remember where I need
to roll next. Helps a bunchwhen I need to stop to anneal.

Panama Bay Jewelers


#3
I also use a magnet for my rolling mill. I stick a opened paper
clip on the manger stuck to the base of the mill then simply move
the other end into the next grove of my mill so I remember where I
need to roll next. Helps a bunchwhen I need to stop to anneal. 

Great ideas. I usually just look at the numbers below each hole on
the draw plate. That is my reference point…